Welcome

(251) 443-5455

Share on FacebookShare on TwitterShare on Stumble UponShare on Google BookmarksShare on DeliciousShare on DiggShare on Reddit

Copyright © 2013 Advanced Compressed Air Technologies, Inc. -All Rights Reserved

Tungsten Carbide Lined Angle CAM Series


A CAM angle nozzle is designed to blast blind surfaces such as mold cavities or behind beams. Tungsten Carbide lined, the nozzles are available in one or three outlets.

Description of Operation

The operator inserts the included nozzle washer into a nozzle holder and screws in the nozzle, turning it by hand, until it seats firmly against the washer.

With all related equipment correctly assembled and tested, the operator points the angle nozzle at the surface to be cleaned and presses the remote control handle to begin blasting. The operator holds the nozzle 18 to 36 inches from the surface and moves it smoothly at a rate that produces the desired cleanliness. Each pass should overlap slightly.

The operator must replace the nozzle once the orifice wears 1/16-inch beyond its original size.

Advantages

Replacement Parts

NW-3 Nozzle Washers

(Pkg of 10)..............................21583

Tungsten Carbide Lined Angle CAM Series

Available Literature:

21978 - Metal-Jacketed, Silicon Carbide-Lined

21979 - Urethane-Jacketed, Silicon Carbide-Lined

21986 - Metal-Jacketed, Tungsten Carbide-Lined

23414 - Rubber-Jacketed, Tungsten Carbide-Lined

24184 - Metal-Jacketed, Boron Carbide-Lined

24185 - Metal-Jacketed, Tungsten Carbide-Lined CT Series